Q: A friend recommended that I try cast bullets from RCBS mould No. 45-250-FN to obtain better accuracy in my USFA PreWar model .45 Colt. He gave me a few handfuls of unsized bullets to try. However, when I went to load them, I noticed that their weight was actually 264 grains instead of the indicated 250 grains. Should I reduce my normal 6.0-grain charge of Alliant Red Dot powder? If so, by how much?
Also, in looking at this bullet design, I am not sure where to apply the crimp. It appears that it has two grease grooves and no crimp groove. Your thoughts would be greatly appreciated!
Incidentally, I read Handloader from cover to cover every issue. I thoroughly enjoy your articles as well as those by John Barsness and Mike Venturino. Please keep up the great work. New Castle, PA
Denne historien er fra February 2021-utgaven av Handloader.
Start din 7-dagers gratis prøveperiode på Magzter GOLD for å få tilgang til tusenvis av utvalgte premiumhistorier og 9000+ magasiner og aviser.
Allerede abonnent ? Logg på
Denne historien er fra February 2021-utgaven av Handloader.
Start din 7-dagers gratis prøveperiode på Magzter GOLD for å få tilgang til tusenvis av utvalgte premiumhistorier og 9000+ magasiner og aviser.
Allerede abonnent? Logg på
OEHLER's New System 89 Chronograph
Measuring Bullet Performance Downrange
The Problem with Low Pressure Loads
Bullets & Brass
Measurements for Rifle Handloading
Handy Techniques for Accurate Ammunition
THE BRASS RING
In Range
Semi-custom Bullet Moulds
Mike's Shoot in' Shack
REVISITING THE 6.5 -06 A-SQUARE
Loading New Bullets and Powders
Cimarron Stainless Frontier .45 Colt
From the Hip
9x18mm Makarov
Cartridge Board
Alliant 20/28
Propellant Profiles
.224 Clark
Wildcat Cartridges