Multiplex Extra 330SC GB

Fly extreme 3D with this receiver-ready model

- Mike Gantt

Gernot Bruckmann is one of the most experienced guys out there at designing and flying successful 3D airframes, and Multiplex teamed up with him to create this awesome Extra 330SC model, which is actually licensed by Extra Aircraft. Some of the most exciting types of RC flying, 3D maneuvers demand that an airframe be almost indestructible and able to withstand high-G loads, and this new Elapor airframe delivers.

UNIQUE FEATURES

I tested the receiver-ready version of this model, which comes with all hinges installed except the rudder. Hinging the rudder requires that you simply snap it to the vertical stabilizer’s hinge halves. When the two make positive contact, there will be a definite click. Mine fit together flawlessly, and the result is a smooth-operating control surface that can be easily removed if needed. The other hinges are wide, flat plastic CA types with four per aileron and four on the horizontal stabilizer/elevator. The tug test verified that all were glued in well at the factory. Control connections are completed with long servo arms, metal rods, and double plastic control horns, all of which were factory positioned, glued, and ready for final adjustment. Setscrews make setup a breeze. With power on and all controls at neutral, you can quickly and easily position your surfaces by hand and tighten up the screws. Adding a drop of blue thread-locker to the screws doesn’t hurt.