Q: A friend recommended that I try cast bullets from RCBS mould No. 45-250-FN to obtain better accuracy in my USFA PreWar model .45 Colt. He gave me a few handfuls of unsized bullets to try. However, when I went to load them, I noticed that their weight was actually 264 grains instead of the indicated 250 grains. Should I reduce my normal 6.0-grain charge of Alliant Red Dot powder? If so, by how much?
Also, in looking at this bullet design, I am not sure where to apply the crimp. It appears that it has two grease grooves and no crimp groove. Your thoughts would be greatly appreciated!
Incidentally, I read Handloader from cover to cover every issue. I thoroughly enjoy your articles as well as those by John Barsness and Mike Venturino. Please keep up the great work. New Castle, PA
Bu hikaye Handloader dergisinin February 2021 sayısından alınmıştır.
Start your 7-day Magzter GOLD free trial to access thousands of curated premium stories, and 9,000+ magazines and newspapers.
Already a subscriber ? Giriş Yap
Bu hikaye Handloader dergisinin February 2021 sayısından alınmıştır.
Start your 7-day Magzter GOLD free trial to access thousands of curated premium stories, and 9,000+ magazines and newspapers.
Already a subscriber? Giriş Yap
OEHLER's New System 89 Chronograph
Measuring Bullet Performance Downrange
The Problem with Low Pressure Loads
Bullets & Brass
Measurements for Rifle Handloading
Handy Techniques for Accurate Ammunition
THE BRASS RING
In Range
Semi-custom Bullet Moulds
Mike's Shoot in' Shack
REVISITING THE 6.5 -06 A-SQUARE
Loading New Bullets and Powders
Cimarron Stainless Frontier .45 Colt
From the Hip
9x18mm Makarov
Cartridge Board
Alliant 20/28
Propellant Profiles
.224 Clark
Wildcat Cartridges
