The castings provided have a rough hole in the centre. In the past, I have made eccentrics for steam engines using solid castings. I machined them to approximate size, drilled holes for the bolts to hold the halves together and then cut the body in halves across the centre using a thin slitting saw. The halves were bolted together and the centre of the work established along the sawcut. The centre was clearly identified and initial drilling and work with the boring bar soon established the hole for the eccentric - a comparatively easy set of operations.
Not so with the current casting. How is it possible to locate a centre (photo 1)? I came up with a solution that I have not seen in print before so thought it worth recording. The bolt holes were drilled, and the strap cut across the centre using a fine slitting saw. The location for the cut was found from the middle of the two flats on each side.
This story is from the {{IssueName}} edition of {{MagazineName}}.
Start your 7-day Magzter GOLD free trial to access thousands of curated premium stories, and 9,000+ magazines and newspapers.
Already a subscriber ? Sign In
This story is from the {{IssueName}} edition of {{MagazineName}}.
Start your 7-day Magzter GOLD free trial to access thousands of curated premium stories, and 9,000+ magazines and newspapers.
Already a subscriber? Sign In
WORKSHOP TIP - Boring Eccentrics
I am making a 1 inch Minnie traction engine and have arrived at the machining of the eccentric straps.
Wenford A 7¼ Inch Gauge 2-4-0 Beattie Well Tank
The stage has now been reached where the well tank body can be completed but beforehand there are some internal details to add.
Vertical Boiler Locomotives
Vertical Boiler Locomotives
Union Nuts, and How to Make Them
These are quite different from those commercially available and are made from copper
SHOWCASE Paul's Engine
One day my son Paul came to me and asked if we could make something in my workshop, so that he could learn engineering processes.
CLUB NEWS
My secret’s out!
Building Dancer - The Boiler
Dancer needed a boiler that would be somewhat larger than the size permitted under the Model Engineering exemptions in the New Zealand regulations.
An Inverted ‘Ross Yoke' Watercooled Stirling Engine
As with all my hot air engines they are cheap to build, mostly from scrap
A Draught Proposal
A Draught Proposal
A Boiler Feed Pump
A Boiler Feed Pump